GRAUPNER mz-24 PRO - Page 100

Specifically, there is the possibility of back-channels re-
ciprocal interference, e.g. a camera drone with separate
camera and drone control or a towing model for mod-
el-parachute.
Scroll between the individual Telemetry menu pages
by pressing the ENT (forward) and ESC (reverse)
buttons. Angled brackets “>” and “<” will appear on
the RX line indicating the direction of additional pag-
es:
BACK
RECV
GAM
EAM
VARIO
GPS
DEC
INC
ENT
SET
ESC
ESC
RX SERVO V6.35<>
REVERSE : OFF
CENTER : 1500µsec
TRIM : –000µsec
LIMIT– : 150%
>OUTPUT CH : 01
LIMIT+ : 150%
PERIOD : 20msec
Telemetry
If only one angled bracket is showing, this indicates
the first or final menu page; scroll only in the direction
indicated.
To change parameters on a menu lines, move the
left-hand line bracket (seen above to the left of the
OUTPUT CH line). Press the INC or DEC button to
move the “>” pointer up or down one line. The brack-
et will automatically skip menu lines which cannot be
changed.
To change a parameter, place the pointer on the menu
line and press the SET button at the right edge of
the screen. The parameter to be changed highlights
white:
BACK
RECV
GAM
EAM
VARIO
GPS
DEC
INC
ENT
SET
ESC
ESC
RX SERVO V6.35 < >
REVERSE : OFF
> CENTER : 1500µsec
TRIM : –000µsec
LIMIT– : 150%
OUTPUT CH : 01
LIMIT+ : 150%
PERIOD : 0msec
Telemetry
Press the INC or DEC buttons to change the value
within the selected range. Press the SET button to
confirm and store to the receiver memory.
Press the ESC button at the top right of the display
to return to the previous page; press the BACK but-
ton at the top left of the Telemetry display to return to
the BASE submenu screen:
BACK
RX SELECT
SETTING & DATA VIEW
SENSOR
RF STATUS VIEW
VOICE TRIGGER
RX1
>>
>>
>>
>>
INC
RES
DEC
ALWAYS
Telemetry
Notices
• If an active warning message appears instead
of the desired Telemetry page menu, then
there is no connection with the receiver. Turn
on the receiver system, bind the receiver or
activate it in the RX SELECT line as described
above in the Basic Operation section (page
99).
• If an active warning message appears un-
expectedly while the Telemetry page menu
is being programmed, the connection to the
receiver system has been suddenly lost. Turn
the receiver system off and on again, or find
the origin of the connection failure, or re-bind
the receiver.
100 Function menu - Telemetry