GRAUPNER mz-24 PRO - Page 99

• To avoid accidental starts, models and
sensors should only be programmed
when the model is on the ground with
the motor turned off or the drive bat-
tery disconnected.
For example, a servo test that acci-
dentally activates the receiver could
cause the model to crash and cause
injury or property damage.
• Consult the safety instructions con-
tained in the Part 1 of the manual in-
cluded in the transmitter packaging.
Telemetry
To change the telemetry settings, from the main dis-
play press the BASE menu gear icon (green “B”) to
bring up the BASE submenu screen:
000
000
000
000
mz
000%
000%
000
000
BATT TIME 00: 01: 23
MODELLNAME 1
M - 1
PHASE 1
000:00.0
000:00.0
4.2V
0:01:23
Press
From the BASE submenu display, press the Teleme-
try icon:
BACK
SYSTEM
BASE
FUNCTION
Model Sel
E.P.A
Model Type
REV/SUB
THR.CUT
Timer
TX ctl
Fail Safe
Trim Step
Servo
Out.Swap
CTL Set
Announce
Telemetry
Press
BACK
RX SELECT
SETTING & DATA VIEW
SENSOR
RF STATUS VIEW
VOICE TRIGGER
RX1
>>
>>
>>
>>
INC
RES
DEC
ALWAYS
Telemetry
Basic operation
The Telemetry menu corresponds to the other menus
of the mz-24 HoTT Pro transmitter; the few deviations
are described below:
If you have bound a receiver as RX1 or RX2 in the
BASE submenu TX ctl, then designate one of the two
receivers as the "telemetry-receiver" by changing the
value of the field to the right of RX1 in the RX SE-
LECT line. It is standard practice to default to the
most recent receiver bound. To change the default
setting ALWAYS, press to highlight the field blue:
BACK
RX SELECT
SETTING & DATA VIEW
SENSOR
RF STATUS VIEW
VOICE TRIGGER
RX1
>>
>>
>>
>>
INC
RES
DEC
ALWAYS
Telemetry
Press the INC or DEC button at the right edge of
the display to change the value. Alternatively, press
the arrow keys ( pq ) to the left of the display screen
to achieve the same result.
Press the  RES button to reset the changed value
back to the default (ALWAYS).
Value Explanation
ALWAYS The transmitter reacts to the
back-channel of the selected receiver
with normal/standard functionality.
4TIME
8TIME
The transmitter reacts to the
back-channel of the selected receiver
with the selected delay.
OFF The transmitter telemetry functions
are turned off.
Notice
Using settings other than the ALWAYS default is
only suggested if two non-connected receivers
are bound to two different transmitters for close
distance use, as the back-channel of one of the two re-
ceivers is often disrupted.
99
Function menu - Telemetry