Attention
In the helicopter AUTOROT phase, always
leave the standard delay time as 0.0s. For
safety reasons, if a switchover is necessary
the phase can be changed immediately and without
delay.
Notice
For all models, the switchover time set here
acts uniformly across all phase-specific set-
tings and all active mixers. The switchover
between phase-dependent mixers should proceed
smoothly.
• CTL Column (Control/Switch)
Use this function to change between phases.
Press the field for the appropriate phase in the CTL
column:
BACK
1.
2.
3.
4.
5.
NORMAL
CPY
DEL
DEC
1.2s
NAM
NEXT
NEW
INC
START
PHASE 3
PHASE 4
PHASE 5
PHASE
SLOW
CTL
PHASE
SET
0.0s NULL
Press
An active display pops up:
BACK
1.
2.
3.
4.
5.
NORMAL
CPY
DEL
DEC
1.2s
NAM
NEXT
NEW
INC
START
PHASE 3
PHASE 4
PHASE 5
PHASE
SLOW
CTL
PHASE
SET
0.0s NULL
Select
CLR
NO
LOGIC
Press NO to terminate the process. Press CLR
to clear any existing values. Press LOGIC to
assign a switch to perform this function. Refer to
Control and Switch Assignment section (page
26) for more information on assigning switches.
Notices
• NORMAL/Phase1 is the default when
none of the assigned phase switches are
in the ON position.
• To avoid function errors, never assign a
switch to both a User Voice Recording and
a Phase function.
• SET Button
To assign individual voice announcements to the
different phases, press the SET button at the up-
per right of the display:
BACK
1.
2.
3.
4.
5.
NORMAL
CPY
DEL
DEC
1.2s
NAM
NEXT
NEW
INC
START
PHASE 3
PHASE 4
PHASE 5
PHASE
SLOW
CTL
PHASE
SET
0.0s NULL
Press
The following display appears:
BACK
PH. VOICE 2
PH. VOICE 3
PH. VOICE 4
PH. VOICE 5
PH. VOICE 6
RES
DEC
INC
PH. VOICE 1
Phase
PHASE 1
Press to highlight the appropriate phase voice val-
ue field. Scroll through the list of available voice
announcements by pressing the INC or DEC
buttons at the right edge. Press the RES button
to clear any selection. In the example below, Voice
Announcement #254 has been selected:
BACK
PH. VOICE 2
PH. VOICE 3
PH. VOICE 4
PH. VOICE 5
PH. VOICE 6
RES
DEC
INC
PH. VOICE 1
Phase
PHASE 1
254_Normal_22k
Press the BACK button at the top left of the dis-
play to return to the main Phase display.
123
Function menu | general - Phase
To Next Page
Loading...
