GRAUPNER mz-24 PRO - Page 131

Rounding Off the Throttle Curve
• CURVE Line ON/OFF Button
Curve profiles are angeled by default. Automati-
cally round off the lines by turning ON the round-
ing function in the CURVE line:
PHASE 1 THR.CRV
SERVO
BACK
IN
OUT
POINT
OFF
INC
ENT
DEC
Y-axis
X-axis
ST ON
CURVE
–030%
+035%
+067%
2
Press
The angled curve lines are rounded:
PHASE 1 THR.CRV
SERVO
BACK
IN
OUT
POINT
ON
INC
ENT
DEC
Y-axis
X-axis
ST ON
CURVE
–030%
+035%
+067%
2
Attention
The curves shown aboveare only for demon-
stration purposes and do notrepresent actual
throttle curves.
Press the BACK button at the top left of the display
to return to the menu selection.
131
Function menu | general - Curve CH 1