GRAUPNER mz-24 PRO - Page 147

Training Mode
During training, the teacher and pupil canmaintain a
comfortable distance. Do not exceed a distance of
164 feet (50 m). No one should be between the teach-
er and pupil: this reduces the feedback channel range
used to connect the two transmitters.
While in Training Mode, the main display of the TEACH
transmitter may look like the example graphic below:
000 000
000
000
mz
000%
000%
000
000
BATT TIME 00: 01: 23
STARLET
M - 1
PHASE 1
000:00.0
000:00.0
4.2V
0:01:23
TX RX
RX 05.5V
The PUPIL transmitter may look like the example
graphic below:
000 000
000
000
mz
000%
000%
000
000
BATT TIME 00: 01: 23
PUPIL
M - 1
PHASE 1
000:00.0
000:00.0
4.2V
0:01:23
If connection between TEACH and PUPIL transmit-
ters is lost during training, the TEACH transmitter au-
tomatically assumes control of the model.
If connection is lost and the trainer-switch is in the
pupil position, acoustic warnings sound, and a warn-
ing message flashes every second at the top left of
the display:
000 000
000
000
mz
000%
000%
000
000
BATT TIME 00: 01: 23
STARLET
M - 1
PHASE 1
000:00.0
000:00.0
4.2V
0:01:23
TX RX
RX 05.5V
No pupil signal
In both examples, bring both transmitters closer to-
gether. If does not restore the connection, immediate-
ly stop using the model and troubleshoot the connec-
tion problem.
Restarting the Trainer Mode
If one of both transmitters have been turned off, the
following active warning will appear in the TEACH
transmitter once the transmitter(s) is turned on:
000 000
000
000
mz
000%
000%
000
000
BATT TIME00: 01: 23
STARLET
M - 1
PHASE 1
000:00.0
000:00.0
4.2V
0:01:23
TX RX
RX 00.0V
Warning
Thr.HOLD
Thr.-POS
Thr.CUT
PHASE
Please select RF ON/OFF
ON
TEACHER SIGNAL
OFF
The following active warning will appear in the PUPIL
transmitter once the transmitter(s) is turned on:
000 000
000
000
mz
000%
000%
000
000
BATT TIME00: 01: 23
SCHÜLER
M - 1
PHASE 1
000:00.0
000:00.0
4.2V
0:01:23
Warning
Thr.HOLD
Thr.POS
Thr.CUT
PHASE
PLEASE select RF ON/OFF
ON
PUPIL SIGNAL
OFF
Pressing the ON button confirms the Trainer Mode is
active. Pressing OFF stops the training mode.
147
Function menu | general - Trainer