GRAUPNER mz-24 PRO - Page 229

Notice
If the telemetry connection is interrupted for lon-
ger than three seconds (and if the transmitter is
not switched off), the last successfully transmit-
ted GPS coordinates are saved in the transmitter’s flash
memory drive. This saved data can be read on the GPS
display using the transmitter control buttons by going
back to the main display or navigating to the GPS dis-
play menu.
ESC (Electronic Speed Controller)
cur-VOLT-min
cur-TEMP-max
30.0 70
QUA 100
-200 -20
30000
cur-RPM-max
cur-AMP-max
00000mAh
CAPACITY
0
0
0 0
00.0V 00.0V
-020°C -020°C
60000
000000rpm 000000rpm 000.0A
000.0A
BACK
NEXT
This display shows the data from a HoTT compatible
brushless controller connected to the receiver with in-
tegrated telemetry.
The display shows the current and maximum electri-
cal values of the drive, the current and maximum tem-
perature of the controller, and the current and maxi-
mum speed of the motor connected to the controller.
Value Explanation
QUA Signal package quality (in percent) of
data sent from the transmitter arriving
at the receiver
cur-VOLT-
min
In volts:
Left side: actual input voltage
Right side: lowest input voltage since
the device has been switched on
cur-
TEMP-
max
In Celsius:
Left side: current controller tempera-
ture
Right side: maximum controller tem-
perature since the device has been
switched on
cur-RPM-
max
In revolutions per minute:
Left side: current motor speed
Right side: maximum motor speed
since the device has been switched on
cur-AMP-
max
In amps:
Left side: Momentary current
Right side: maximum current since the
device has been switched on
Microcopter Display
VOLT
TIME
mAh
ALT
DIR
CUR
00.0V
00:00
0000
0000m
000
000.0A
00
000kmh
00000m
000
R
- 58dB
BACK
NEXT
This screen displays the data of a HoTT-compatible
microcopter. The display screen appears after the
electric air, Vario and GPS module screens.
Value Explanation
VOLT Actual voltage
Time Time device has been active
mAh Battery charge used since the device
has been turned on
00 Satellite position number
km/h Above-ground speed (in kilometers per
hour) calculated by the GPS system
ALT Current altitude relative to starting
location
DIR Direction of movement
CUR Momentary current (in amps)
m Distance (in meters) from the starting
location calculated by the GPS system
000 Position (in angular degrees) relative to
the starting location calculated by the
GPS system
Messages from the microcopter sensor are displayed
in the bottom line of the display.
229
Telemetry data display