Press NO to cancel. Press GLOBAL to change the
selected model memory to Global (transmitter-specif-
ic HoTT-Synchronization):
BACK
NEXT
01
MODEL NAME 1
02
03
04
05
06
SEL
NEW
IMP.M
EXP.M
RES
CPY
MODEL NAME 1
MODEL NAME 2
MODEL NAME 3
MODEL NAME 4
MODEL NAME 5
MODEL NAME 6
G
G
G
G
To change from Global to Standard (model-specific
HoTT-Synchronization), then the selection window
appear as below:
BACK
NEXT
01
MODEL NAME 1
02
03
04
05
06
SEL
NEW
IMP.M
EXP.M
RES
CPY
MODEL NAME 1
MODEL NAME 2
MODEL NAME 3
MODEL NAME 4
MODEL NAME 5
MODEL NAME 6
G
G
G
Select
model
NO
G
Touch NO to cancel. Press MODEL to change the
selected model memory back to Model (model mem-
ory specific HoTT-Synchronization).
• NOTE: Re-bind all receivers after changing the
HoTT Synchronization!
• Global bound receivers react to the signals of all
of the global bound model memories saved in the
transmitter. For safety reasons a model memory
change is only possible if the receiver system is
turned off.
CAUTION
If a receiver system is accidentally
turned on after a model memory
change, it will react to control move-
ments of every global-bound model memory as
soon as a valid signal is emitted from the trans-
mitter.
• Model-specific bound receivers react exclusively
to the signal coming from the specifically assigned
model memory. Accidentally using a non-specifi-
cally assigned model memory is NOT possible.
Receivers turned on after a model memory change
will automatically pass into Fail-Safe Mode.
Tip
Refer to the Import/Export from SD Card section for
additional information regarding HoTT-Synchronization
after the copying, importing or exporting process (page
54).
NEXT (Page Change)
Press the NEXT button at the top right cornier of
the display to scroll through additional Model Memory
Lines:
BACK
NEXT
01
MODEL NAME 1
02
03
04
05
06
SEL
NEW
IMP.M
EXP.M
RES
CPY
MODEL NAME 1
MODEL NAME 2
MODEL NAME 3
MODEL NAME 4
MODEL NAME 5
MODEL NAME 6
G
G
G
Press
There are six lines per screen:
BACK
NEXT
07
MODEL NAME 1
08
09
10
11
12
SEL
NEW
IMP.M
EXP.M
RES
CPY
MODEL NAME 7
MODEL NAME 8
MODEL NAME 9
MODEL NAME 10
MODEL NAME 11
MODEL NAME 12
The screens are cyclical; pressing NEXT after reach-
ing the screen displaying Lines 25 - 30, the first screen
will reappear, displaying Lines 01 - 06.
NOTE: Pressing BACK will not recall the previous
screen. Pressing BACK will bring up the last major
menu, e.g. either the BASE submenu display or the
Main Menu.
SEL (Change Model)
Press to highlight the Model Memory line to be made
the active model. In this example Line 02 - Beaver:
BACK
NEXT
01
STARLET
02
03
04
05
06
SEL
NEW
IMP.M
EXP.M
RES
CPY
STARLET
BEAVER
GRAUBELE
MODEL NAME 4
MODEL NAME 5
MODEL NAME 6
Press
Line 02 is highlighted blue:
BACK
NEXT
01
STARLET
02
03
04
05
06
SEL
NEW
IMP.M
EXP.M
RES
CPY
STARLET
BEAVER
GRAUBELE
MODEL NAME 4
MODEL NAME 5
MODEL NAME 6
40 Base menu - Model selection
To Next Page
Loading...
