WIZ.
NORMAL
Gyro Gain
000%
Gyro Suppression
Governor RATE
Governor ACT
+023%
ON
067%
RES
DEC
INC
Gyr/Gover
With a control assigned in the CH 8 line of the
BASE sub-menu CTL Set, for example the propor-
tional dial DVx, this value can also be proportion-
ally varied.
Press the WIZ. button again to advance to the Throt-
tle Hold display:
THR.HOLD (Throttle Hold)
During competition, is expected that gas engines be
completely turned off. In the training phase, this is a
bit inconvenient since it would be necessary to restart
the engine after each autorotation training landing.
(Refer to FUNCTION sub-menu THR.HOLD (page
170) for additional information.)
To make the appropriate settings during the training
phase so the gas engine can be kept idling during the
autorotation phase without the clutch engaging or so
any electric drive is definitely off, as shown below:
WIZ.
ACT
CTL
SET
DEC
RES
INC
–100%
ON
INH
THR.HOLD
Tip
There is an alternative emergency off option in the BASE
submenu Throttle Cut (page 66).
Press the WIZ. button again to advance to the final
display:
HELICOPTER
3 Sv(140°)
ELE.POWER
M/TYPE SWASH P/TYPE
ENT
Press the ENT button to return to the BASE menu.
IMP.M (Import From SD Card)
Once a memory card is inserted into an operational
transmitter, a blue memory card icon appears at the
top right of the main display:
000
000
000
000
mz
000%
000%
BATT TIME 00: 01: 23
MODELLNAME 1
M - 1
PHASE 1
000:00.0
000:00.0
4.2V
0:01:23
To import compatible models into the transmitter
memory from the memory card, open the BASE sub-
menu Model Sel:
BACK
NEXT
01
STARLET
02
03
04
05
06
SEL
NEW
IMP.M
EXP.M
RES
CPY
STARLET
BEAVER
GRAUBELE
MODEL NAME 4
MODEL NAME 5
MODEL NAME 6
Choose from the list of empty model memories. For
this example Line 04: MODEL NAME 4 has been se-
lected. Press to select and highlight the field blue:
BACK
NEXT
01
STARLET
02
03
04
05
06
SEL
NEW
IMP.M
EXP.M
RES
CPY
STARLET
BEAVER
GRAUBELE
MODEL NAME 4
MODEL NAME 5
MODEL NAME 6
Press the IMP.M button in the middle of the right col-
umn to switch to the display of the data model saved
on the SD card:
54 Base menu - Model selection
To Next Page
Loading...
