Hakko Electronics Monitouch V9 Series User Manual

1-6 1. Overview
1.2.3 LAN
LAN Port Specifications
Maximum number of connectable devices
Pin Arrangement
Applicable Devices
1.2.4 Network Communication Port (Under Development)
An optional communication interface unit “CUR-xx” (under development) is required to perform network communication.
For more information, refer to the specifications for each unit.
CAUTION
The LAN connector uses the same type RJ-45 connector as MJ1 and MJ2.
Check the indication on the unit and insert a cable into the correct position.
Item
Specifications
100BASE-TX (IEEE802.3u) 10BASE-T (IEEE802.3)
Baud Rate 100 Mbps 10 Mbps
Transmission method Base band
Maximum segment length 100 m (between the node and the hub)
Connecting cable 100 , UTP cable, category 5
Protocol UDP/IP, TCP/IP
Port Auto-MDIX, Auto-Negotiation functions compatible
Number of concurrently opened ports 8 ports
Maximum number of connectable
devices
256 sets each via one single port PLC1 - PLC8
LAN
Port2
Port1
Port3
Port8
PROGRAMMER
PROGRAMMER
No.0
No.0
No.1
No.255
No.255
Company A
256 sets
(Registered to PLC table in screen program)
No. of Ports
8
Company B
256 sets
(Registered to PLC table in screen program)
V9i
LAN
RJ-45
No. Name Contents
1TX+ Send signal +
2TX Send signal 
3RX+ Receive signal +
4
NC Not used
5
6RX Receive signal 
7
NC Not used
8
12345678
Applicable Devices
PLC, slave communication (Modbus TCP/IP), computer (screen program transfer, V-Server, etc.)

Hakko Electronics Monitouch V9 Series Specifications

General

Brand	Hakko Electronics
Model	Monitouch V9 Series
Category	Monitor
Language	English