Harmonic ProView 7100 - Page 114

Chapter 7 Device Configuring Using EMS Multiplex & Decoding Outputs
© 2012 Harmonic Inc. 114 ProView 7000 v.2.6, Rev. E
7.3.8.2 Video Parameters Tab
The Video parameters tab provides the EMS user the following information and set-up
capabilities:
General Video processing parameters:
■ Decoding Codec – selects the video decoding mode.
Options:
❑ Automatic
❑ MPEG-2
❑ H.264
■ Display Format – selects the video display format.
Options:
❑ SD
❑ HD
❑ Automatic
The video output set-up depends on the display format selected:
Standard Definition (SD) Digital and Analog Output parameters:
■ Video Format – selects the video format.
Options:
❑ NTSC
❑ PAL-B/G, -I, -D, -M, -N
❑ French SECAM – The CV monitor output—outputs Russian SECAM as French SECAM.
■ Aspect Ratio Conversion – selects the aspect ratio conversion for the output stream. To be
performed if the incoming stream aspect ratio is not the same as the configured output
aspect ratio.
Options (related to selected aspect ratio):
❑ 4:3 Aspect ratio
•Center-cut
• Letterbox
• Full Screen
•AFD
❑ 16:9 Aspect ratio
• Pillarbox (Side-bars)
•Center-cut
• Full Screen
•AFD
■ Aspect ratio – selects the aspect ratio.
Options:
❑ 4:3
❑ 16:9
❑ Pass Through