Need help?Do you have a question about the HBM WE2107 and is the answer not in the manual?
General| Accuracy class | C3 |
|---|---|
| Maximum number of verification intervals | 3000 |
| Output resistance | 350 Ω ± 3 Ω |
| Rated output | 2 mV/V ± 0.1% |
| Supply voltage | 5-15 V DC |
Details the relationship between the parameter menu and implemented commands.
Explains the syntax, parameters, delimiters, and character sets for commands.
Describes how the WE responds to valid, invalid, and parameter queries.
Describes how the WE responds to command inputs, noting no response for invalid input.
Details the ASCII format and constant output length for parameter queries.
States that the WE does not respond to incorrect or unknown commands.
Covers binary and ASCII output formats for measured values.
Explains how password protection secures scale curve and identification settings.
An alphabetical list of all commands with their function and page reference.
Commands for setting up communication via RS-232 or RS-485 interfaces.
Instructions for adjusting the default curve and gravitational acceleration correction.
Adapting the WE characteristic curve and scaling measured values.
Reducing scale non-linearity using polynomial third-order correction.
Commands to configure filter selection, filter mode, and zero tracking.
Commands related to data output, tare, and gross/net selection.
Covers password management, error memory, and overflow counters.
Monitoring parameter changes for legal for trade compliance.
Setting up communication with an external display via serial link.
Configuring print protocols, escape sequences, and print formatting.
Commands for setting the date, time, and time mode.
Configuring button functions and digital input behavior.
Commands for filling, dosing, tank weighing, and limit switch configuration.
Prerequisites and steps for connecting WE units to a bus system.
Methods for connecting multiple WE units consecutively or all at once.
Specifying the output format (ASCII or binary) for data output.
Setting and synchronizing the baud rate for serial communication.
Procedure for scanning the bus to determine address occupation and configuration.
Performing measurement queries on connected WE units in bus mode.
Broadcasting commands to set parameters on all connected WE units.
To Next Page
