HBM WE2107 - WE2107 External Display Control Commands

WE2107 - Communication commands
86
I1820-1.3 enHBM
3.9 Commands for setup the control of an external
display
The commands are used to setup the communication with the external display via the
second serial link.
D Protocol UART2 FUB
D Protocol external display EDP
D Start character EDS
D CRC character EDC
D End character 1 ED1
D End character 2 ED2
Via the second serial link an external display can be connected.
Baud rate: 1200...9600
Parity bit: non / even
Type: RS232
Update rate: 5 / sec.
Protocol: no protocol (just send out)
Hardware – protocol (DTR)
Software – protocol (DC1/DC3/DC4)
The protocol has to be defined in the parameter menu (UART2/FUNCT) or with the
command FUB. The baudrate can only be selected in the parameter menu (there is no
command available)