HBM WE2107 - WE2107 Data Output Format Configuration

WE2107 - Communication commands
140
I1820-1.3 enHBM
4.3 Setting the data output
For data output using the command MSV?; the output format must previously have been set
in all the modules. To do this, proceed as follows:
1. Enter the broadcast command ;S98;
All the WEs execute the command, but do not send a response.
2. Use the COF
command to specify the output format
(e.g. COF4; for ASCII output)
3. Use the command TDD
1; to save the setting power fail safe in the EEPROM.