HBM WE2107 - WE2107 Introduction and Appropriate Use

5
WE2107 - Communication commands
I1820-1.3 en HBM
1 Introduction and appropriate use
The WE2107 digital weighing electronics are weighing electronics for non‐automatic
weighing instrument (NAWI). They include all the requisite weighing functions for this
application:
D Digital filtering
D Adjusting the factory characteristic curve
D Adjusting the scale characteristic curve
D Linearization
D One, two or three ‐range display
D Output scaling of the measured values
D Range monitoring of the display values (OIML, NTEP)
D Zero setting ("2 %)
D Tare
D Gross/net selection
D Standstill recognition
D Zero on start‐up
D Automatic zero tracking
D Calibration switch with calibration counter
D Gravitational acceleration correction via a settable factor
D Nonvolatile parameter storage
D Parameter password protection
A command set for filling and dosing extend the field of applications.
The digital serial interface for remote control is a RS‐232 interface or RS‐485 (2wire)
interface. With RS‐485 up to 32 bus members can be connected to the bus system.
The abbreviation WE is also used for the WE2107 weighing electronics in the following text.