HBM WE2107 - Limit Values Switches

127
WE2107 - Communication commands
I1820-1.3 en HBM
Limit values
(Limit values switches)
Property Content Comment
Command string LIV
No. of parameters 1
Parameter range P1= 1…4, P2=0,1,2, P3=0/1
P4=P5= 0...+
99999
Factory setting x, 0, 0, 0, 0 for all limit values deactivated
Response time < 15 ms
Password protection No
Relevant for legal for
trade
No
Parameter backup With command TDD1
Master input LIV(P1),<P2>,<P3>,<P4>,<P5>; No response
Master query LIV(P1)?;
WE response P2,P3,P4,P5 crlf P2,P3= 1 charac
ter,
P4,5 = each
6 characters
Note: ( ) required parameters, < > optional parameters for parameter input
Function:
The WE contains four limit value switches with selectable hysteresis. These can monitor
gross or net measured values. The monitoring speed depends on the set output rate. Moni
toring is always implemented, even when there is no communication via the serial interface.
LIV