9
Operating instructions
HERMA 400 OPERATION (VIA THE HERMA 400 CONTROL)
3.28 US (130519) 113/154
9.9 Menu 200 Transfer data
9.9.1 201 Application type
As factory setting one of the following application types is selected via parameter 201 (available for
Technical Service only):
00 Rigid beak: Using a „normal“ rigid dispensing beak.
01 X17: Pivot beak: Using a pivot beak, connected to X17.
02 X17: Moving beak: Using a moving beak, connected to X17.
03 X17: Transverse unit: Using a transverse transfer unit, connected to X17.
04 X17: Telescope: Using a transfer unit (linear unit), connected to X17.
05 X17: Blow box: Using a transfer unit „Blow box“, connected to X17.
06 CAN: Type211: Using the functionality of the semi-automatic machine type 211, with two drive
units (one for the applicator, the other for the roller unit).
07 CAN: Moving beak: Using a moving beak, connected via CAN bus ( / only).
08 CAN: Transverse unit: Using a transverse transfer unit, connected via CAN bus ( / only).
09 CAN: Telescope: Using a transfer unit (linear unit), connected via CAN bus ( / only).
10 CAN: Mov. beak + tel.: Using moving beak and transfer unit, connected via CAN bus ( / only).
11 CAN: Beak + mov. tel.: Using dispensing beak and moving transfer unit, connected via CAN bus ( /
only).
12 CAN: Typ 152: Use on a type 152C wrap-around labeler.
Parameters of the transfer data menu will show, underneath the parameter number, the indication of
the application type selected in the format „Axx“, wlth xx = 00 – 10, e.g.
211 Pivo beak type
A01 Label related
To Next Page
Loading...
