3.28 US (130519) 79/154
6 Transport, installation, storage and
connection
Never stand or walk under suspended loads! Swinging or falling parts may
lead to injury or a risk to life.
Before transporting the applicator, disconnect it from the mains supply.
6.1 Transporting the applicator
When you transport the applicator/the machine using a forklift/pallet truck, note the following
requirements:
The means of transport must be approved for the weight of the machine.
Note the safety regulations for transporting and lifting heavy loads. The
driver of the forklift/pallet truck must have the appropriate qualification.
Guide the forks between the machine feet or the palette. Be aware of the
machine’s center of gravity.
The forks must extend so they are sticking out on the other side of the
machine or the palette.
When transporting the applicator with the label roll installed the roll could
fall down during transport . Remove the roll of labels when transporting
the applicator. Otherwise this could lead to injuries.
6.2 Installing the applicator
Never store or use flammable substances in the vicinity of this applicator.
Flammable substances may catch fire and cause explosions causing
serious injury or death.
The applicator must not be used in explosive atmospheres.
If the applicator is not properly mounted and fixed it could become loose
when switched on. Mount the applicator appropriately before supplying
energy. Otherwise this could lead to serious injury.
If you should notice damage due to transport when you unpack the machine inform your HERMA sales
office immediately.
To Next Page
Loading...
