9
Operating instructions
HERMA 400 OPERATION (VIA THE HERMA 400 CONTROL)
3.28 US (130519) 119/154
9.9.28 280 Label check on / off
Activate or deactivate a missing label control (directly via sensor or indirectly via vacuum monitoring).
9.9.29 284 Label check aft. feed
With PWL2 and activated label check only.
Determines the procedure to follow if after dispensing no label can be detected on the vacuum pad.
None:
The cycle in continued normally irrespective of the result of the missing label check.
Alarm message:
The cycle is stopped and an error message displayed.
Repeat feeding:
Dispensing is repeated. An error message is shown after a second failed attempt.
9.9.30 285 Lab. check aft. transf.
With PWL2 and activated label control only.
Determines the procedure to follow if after label transfer a label can still be detected on the vacuum
pad.
None:
The cycle in continued normally irrespective of the result of the missing label check.
Alarm message:
The cycle is stopped and an error message displayed.
Repeat transfer:
Transfer is repeated. An error message is shown after a second failed attempt.
9.9.31 286 Label check start delay
With PWL2 and activated label control only.
The time given to any label control unit (e.g. a vacuum control) to become operational.
To Next Page
Loading...
