Herma 400 - Unwinder Disc; Diminishing Reel Diameter; Bluetooth; Bus Adress (RS485)

9
Operation (via the HERMA 400 control) Operating instructions HERMA 400
124/154 3.28 US (130519)
02 Medium: 
Here, minor changes of the label overfeed are accepted. Distances will conform with average values
that
are continuously determined anew.
03 Little: 
With this setting an error messge is issued if several labelling processes
in a row are out of tolerance.
Distances will conform with average values that are continuously determined anew.
See also section „186 Label tolerance“ on page 110.
9.12.9 947 Unwinder disc
Enter here the diameter of the unwinder disk as follows (entries in mm or inch) in order to optimize
control of the end of reel signal:
00: 300mm/12“
01: 400mm/16“
02: 500mm/20“
03: 600mm/24“
9.12.10 948 Diminishing reel diameter
With PWL2 only.
The diameter of the sleeve upon which the output „Diminishing reel“ (X10.5 DIM) is activated. 
Range: 0.0–3276.7 mm.
9.12.11 980 Bluetooth
With PWL2 only.
Enter here the way Bluetooth is handled:
00: 
Bluetooth is off.
01: 
Bluetooth is activated manually with the key combination
+ + .
02: 
Bluetooth connection is allowed only vi
a a registered Bluetooth device.
9.12.12 990 Bus adress (RS485)
With PWL2 only.
The address of the applicator if integrated in a network via RS485.
9.12.13 992 Display add. output
With PWL2 only.
For Technical Service only.
9.12.14 997 Serial no. applic.
The applicator number as indicated on the type label. Required for the Bluetooth name of the
applicator.