Herma 400 - Table of Contents


Operating instructions
HERMA 400 TABLE OF CONTENTS
3.28 US (130519) 5/154
Table of Contents
1 Overview of the applicator 11
2 General information 15
2.1 Handling of the documentation 15
2.2 Explanation of symbols 15
2.2.1 Signal words 15
2.2.2 General designations 16
3Safety 17
3.1 Important Safety Information 17
3.1.1 Signal word definitions 17
3.1.2 Mandatory signs 18
3.2 Personal protective equipment 18
3.3 Symbols on the applicator 19
3.4 Proper use of the applicator 20
3.5 Responsibility of the operator 21
3.6 Personnel 22
4 Applicator description 23
4.1 Sub-assemblies 23
4.1.1 Standard unwinder 24
4.1.2 Motorized unwinder – Slim line version 28
4.1.3 Motorized loop-type unwinder – Slim line version 34
4.1.4 Label web brake 39
4.1.5 Label sensor FS03 41
Work mode (normal mode) 41
Setting mode 42
4.1.6 Label sensor optoelectronic 46
4.1.7 Dispensing sytems 48
Rigid/Straight dispensing plates 48
Dispensing plate, 15° angular 49
Pivot beak / Application unit 50
Moving beak 51
4.1.8 Transfer systems 52
Telescope 52
Transverse transfer system 53
4.1.9 Drive/Transport roller 57
4.1.10 Standard rewinder 58
4.1.11 Motorized rewinder – Slim line version 64
5Technical Data 73
5.1 Dimensions / weight (configuration examples) 75
5.2 Inputs / outputs (X10) (option, standard signals) 76
5.3 Inputs / outputs (X19) (option, extended signals) 77
6 Transport, installation, storage and 