3.28 US (130519) 95/154
8 Putting out of operation
If the applicator does not have a power plug, the unit must only be
disconnected by a qualified electrician in accordance with national and
local electrical codes. Observe the wlrlng diagram included wlth the
documentation.
Applicators which are part of a larger machine structure are usually switched off with the main switch
for the entire setup (see also the respective separate manual for that machine).
Single applicators are put out of operation as shown here.
> Press switch-on key 1 at the applicator.
The light 4 beside the key must be off.
> Disconnect power plug from mains.
8.1 End-of-life disposal
In case of disposal, please refer to your local recycling system.
The product should not be mixed with other commercial wastes for disposal at the end of its working
life.
To prevent possible harm to the environment or human health from uncontrolled waste disposal,
please separate this from other types of wastes and recycle it responsibly to promote the sustainable
reuse of material resources.
To Next Page
Loading...
