9
Operation (via the HERMA 400 control)
Operating instructions HERMA 400
130/154 3.28 US (130519)
Address 01 thru 20 for applicator in field bus operation
Address 21 thru 28 for applicator with config protocol.
A change in address will be effective only after the applicator was switched off. When using a RS232
interface the applicator will react to any address.
9.12.26 992 Display add. output
With PWL2 only. With this parameter various status data for service purposes are shown. These details
may be required by our service staff in case of a malfunction. See also the explanation with the
description of error messages SM910, SM913, SM919.
0: Reset this function.
148: Details will be shown temporarily. The information will disappear after switching the applicator off
and then on again.
400: Details will be shown permanently until the function is reset (set this parameter to 0).
To Next Page
Loading...
