3
Safety
Operating instructions HERMA 400
20/154 3.28 US (130519)
3.4 Proper use of the applicator
Risk due to using the applictor in a way that is not intended. Always use
the applicator only for its intended use, which is unwinding label rolls,
dispensing labels and rewindig the backing paper. Any use other than the
purpose described above, in particular using the system to wind any
materials other than rolls of labels, is considered unintended use and is
prohibited. Unintended use could lead to unforeseen action and lead to
serious injuries.
> Use the applicator as intended.
The HERMA 400 applicator is an electronically-controlled device that is used to apply different
adhesive labels to a wide variety of products.
The labeler dispenses from the backing paper one label after the other at the dispensing plate.
Transport of the label web is effected via a pair of rollers driven by a servo motor.
You can use the applicator to unwind label rolls, dispense labels from the backing paper and then roll
up the backing material.
The HERMA 400 applicator is to be used in industrial environment only. It must not be used in private
environment.
The applicator can be configured for different needs and applications. This is done, apart from using
different sub-assemblies (see section
4.1 as of page 23), by setting various parameters with the help
of the integrated control (see chapter 7 as of page 93).
The manufacturer/distributor cannot be held liable for any damage or injuries which result from
improper use. ln such a case, the user assumes liability.
Keep the applicator in optimal working order.
Proper inspection and maintenance needs to be performed regularly as outlined in this manual. Any
disturbances or faults must be eliminated immediately.
> Follow all operating instructions.
The applicator must only be operated by trained personnel and in accordance with the operating
instructions outlined in this manual.
> Observe all safety requirements.
The applicator has been designed according to the latest technologies in mechanical and electrical
engineering and according to recognized safety rules. Nevertheless, the use of this system may imply
danger to life and limb of the user or a third party. Also, there is potential for damage to the applicator
and other assets. All safety rules outlined in the manual must be followed to minimize the risk of injury
or property damage.
To Next Page
Loading...
