Herma 400 - Roller Unit Start Delay; Roller Unit Stop Delay

9
Operating instructions
HERMA 400 OPERATION (VIA THE HERMA 400 CONTROL)
3.28 US (130519) 115/154
————————The following parameters will appear only if parameter 201 (available only for
Technical Service) is set to „CAN: Type 211“.————————
9.9.7 217 Roller unit start delay
This parameter will appear only if parameter 201 (available only for Technical Service) is set to „CAN:
Type 211
“.
The distance in mm roller unit and pivot beak remain activated after stopping the web transport. This
value usually does not have to be modified.
The time in ms that elapses between product insertion and start of labeling. This delay is required if
labeling is started by product detection, e.g. via light scanner.
9.9.8 218 Roller unit stop delay
This parameter will appear only if parameter 201 (available only for Technical Service) is set to „CAN:
Type 211
“.
The distance in mm roller unit and pivot beak remain activated after stopping the web transport. This
value usually does not have to be modified.
——————————End of parameters for type 211——————————