3
Operating instructions HERMA 400 S
AFETY
3.28 US (130519) 19/154
3.3 Symbols on the applicator
These symbols / hazard notification labe
ls are used on the applicator.
Missing safety labels could lead to disregarding possible dangerous
situations. Ensure that all symbols and signs are in a condition that is easy
to read at all times. Replace any damaged signs or labels. Illegible signs
can lead to dangerous situations.
Risk of electric shock. 110-240 Volts
may be present.
Disconnect all sources of supply and
wait for five minutes before opening the
rear cover or touching the connector
pins!
If components are worked while the
applicator is not disconnected from
mains on this could cause electrocution.
In this specially designated area, work
must be performed only by trained
electricians. Unauthorized persons are
not permitted to open the designated
area.
Risk of being drawn in.
Do
not reach into the area where the
feed roller draws in the web when
machine is on!
This could lead to serious injuries.
To Next Page
Loading...
