Herma 400 - Page 8


T
ABLE OF CONTENTS Operating instructions HERMA 400
8/154 3.28 US (130519)
9.9.29 284 Label check aft. feed 119
9.9.30 285 Lab. check aft. transf. 119
9.9.31 286 Label check start delay 119
9.10 Menu 400 Format 120
9.10.1 410 Format load 120
9.10.2 420 Format save 120
9.10.3 422 Format save Enter name 120
9.10.4 430 Format delete 120
9.11 Menu 500 Batch 121
9.11.1 510 Batch size 121
9.12 Menu 900 System 122
9.12.1 910 Rotate display drehen 122
9.12.2 912 Sprache / Language 122
9.12.3 915 Ready screen 122
9.12.4 940 Alarm message after missing labels 123
9.12.5 941 Alarm message after end of reel 123
9.12.6 942 Alarm message after undefined web move 123
9.12.7 943 Alarm message after start sequ. too close 123
9.12.8 944 Monitoring quality 123
9.12.9 947 Unwinder disc 124
9.12.10 948 Diminishing reel diameter 124
9.12.11 980 Bluetooth 124
9.12.12 990 Bus adress (RS485) 124
9.12.13 992 Display add. output 124
9.12.14 997 Serial no. applic. 124
9.12.15 950 Unwinder oper. modes 125
9.12.16 951 Unwinder output 125
9.12.17 952 Loop unwinder 126
9.12.18 953 Loop unwinder output 127
9.12.19 954 Unwinder Mode 128
9.12.20 955 Rewinder Mode 128
9.12.21 956 Loop unwinder Mode 128
9.12.22 957 Rewinder output 128
9.12.23 958 Unwinder protection 1 129
9.12.24 959 Unwinder protection 2 129
9.12.25 990 Bus adress (RS485) 129
9.12.26 992 Display add. output 130
10 Cleaning, maintenance, service 131
10.1 Maintenance schedule 132
11 Troubleshooting 133
11.1 Indication of malfunctions 133
11.2 List of malfunctions (indicated via display) 134
11.2.1 SM106 Missing label at dispensing beak 134
11.2.2 SM107 End of label web 134
11.2.3 SM108 Dispensing unit does not reach home position 134
11.2.4 SM109 Dispensing unit does not leave home position 134
11.2.5 SM110 Dispensing unit does not reach work position 134
11.2.6 SM111 Dispensing unit does not leave work position 134
11.2.7 SM113 Transfer unit does not reach home position 134