Hitachi PSC-A1T Technical Catalogue

4 Individual remote controls
PC-ART
TCGB0106 rev.0 - 12/2014
126
5 Press the SELECT DAY/SCHEDULE ▲ ▼ button to adjust the "minutes" and, once set,
press OK. The "minutes" will remain xed and the switch-off "hour" will ash.
:
SET
1
SCHEDULE
ON

OFF
:
6 Set the switch-off time by following the same procedure as the switch-on time. The
schedule will be stored in the memory and all the available schedule will reappear (1, 2,
3, 4, S).
NOTE
Repeat from step 2 onwards to adjust the other schedule settings.
:
SET
1
SCHEDULE
ON

OFF
:
7 By pressing the TIMER button, SET and SCHEDULE are turned off and the system
switches to operation mode.
:
S
NEXT
SCHEDULE
OFF
:
Mon
• Assigning timer schedules to the days of the week.
1 Press the TIMER button for more than 3 seconds and SET will appear. All the days of the
week will be displayed along with the schedule numbers (as explained in the previous
point).
:
SET
Mon Tue
Wed
Thu Fri
Sat
Sun 1234S
ON

OFF
:
2 Press the DAY ▼ button until the desired day appears. When pressed, the days of the week
will ash: [Mon]
[Tue]… [Sun][Mon~Sun][Mon~Fri][Sat, Sun][Mon]… If
several days ash, the same setting will apply to all of these days.
3 Press the SCHEDULE ▲ button until the desired schedule number ashes.
:
SET
Mon Tue
Wed
Thu Fri
Sat
Sun 1234S
ON

OFF
:
4 Press OK; the schedule number selected in step 3 applies to the days set in step 2. Press-
ing OK will either activate or deactivate the schedule. If it is activated, the word SCHED-
ULE will be displayed above the switch-off time.
:
SET
Mon Tue
Wed
Thu Fri
Sat
Sun 1234S
SCHEDULE
ON

OFF
:
5 Press the TIMER button; the system will exit the programming mode (SET will switch off)
and return to operation mode.
:
Mon
NEXT
SCHEDULE
OFF
:
• Cancelling the timer
In operation mode, press and hold DAY/SCHEDULE ▲ ▼ simultaneously for at least 3 sec-
onds. NEXT SCHEDULE will ash. (The entire timer setting is cancelled)
:
Mon
1234S
NEXT
SCHEDULE
ON
:
In timer cancellation mode, press and hold DAY/SCHEDULE ▲ ▼ simultaneously for at least
3 seconds. NEXT SCHEDULE will appear. (Timer activation)
:
Mon
1234S
NEXT
SCHEDULE
ON
:
• Setting the temperature change (energy-saving mode).
1 Follow the switch-on/switch-off setting procedure in steps 1 and 2 of the “Setting the timer
schedules” section and select program "S".
:
1234S
SCHEDULE
ON

OFF
:
SET
2 Follow the switch-on/switch-off setting procedure in steps 4, 5 and 6 in the “Setting the
timer schedules” section and set the switch-on/switch-off time. This will bring up the set-
ting temperature.
:
1234S
SCHEDULE
ON

OFF
:
SET

Hitachi PSC-A1T Specifications

General

Brand	Hitachi
Model	PSC-A1T
Category	Controller
Language	English