8.2 PSC-6RAD
8.2.1 Safety summary
DANGER
• DO NOT pour water into the remote control switch (hereafter called “controller”). This product is equipped with electrical
parts.
• If poured, it will cause a serious electrical shock.
CAUTION
• DO NOT perform installation work and electrical wiring connection by yourself. Contact your distributor or dealer of HITACHI and ask
them for installation work and electrical wiring by service person.
• The specied cable should be used to connect room air-conditioner and adapter, and controller and adapter. If not it may result in an
electrical shock or a re.
DO NOT install the indoor unit, outdoor unit, controller and cable at such places as;
• Where there is oil vapour and the oil is dispersed
• Where the hot springs are near (in a sulphuric environment)
• Where generation, owing, staying or leaking of ammable gas is detected
• Where the sea is near (in the salty environment)
• An acid or alkaline environment
DO NOT install the indoor unit, outdoor unit, controller and cable within approximately 3 meters from strong electromagnetic wave radia-
tors such as medical equipment. In case that the controller is installed in a place where there is electromagnetic wave direct-radiation,
shield the controller and cables by covering with the steel box and running the cable through the metal conduit tube.
In case that there is electric noise at the power source for the indoor unit, provide a noise lter.
This appliance must be used only by adult and capable people, having received the technical information or instructions to handle properly
and safely this appliance.
Children should be supervised to ensure that they do not play with the appliance.
8 Control support devices
PSC-6RAD
TCGB0106 rev.0 - 12/2014
708
To Next Page
Loading...
Need help?
General
