4 Individual remote controls
Receiver kit for wireless remote control
TCGB0106 rev.0 - 12/2014
213
4
Power failure
• All the indications are OFF.
• Once the unit is stopped by the power failure, the unit will not be started again although the power recovers. Perform
the starting procedures again.
• In case of instantaneous power failure within 2 seconds, the unit will be started again automatically.
Electric noise
There could be a case that all the indications are OFF and the unit is stopped. This is occurred by the activation of the micro
computer for the unit protection from the electric noise.
Perform the starting procedures again.
4.5.8.3 Emergency operation
“COOL” and “HEAT” switches are used for emergency operation when the wireless remote control (PC-LH3(A/B)) is unus-
able by batteries shortage, etc.
On the wall receiver kit On the panel receiver kit
EMERGENCY
COOL
HEAT
RUN
DEF
FILTER
TIMER
Switch “HEAT”
Switch “COOL”
EMERGENCY
COOLHEAT
RUNFILTER DEFTIMER
Switch “HEAT
Switch “COOL”
1 Switch “COOL”:
- Press “COOL” so that the cooling operation is started.
- Press “COOL” again so that the cooling operation is stopped.
2 Switch “HEAT”:
- Press “HEAT” so that the heating operation is started.
- Press “HEAT” again so that the heating operation is stopped.
NOTE
• The setting temperature and the fan speed for cooling/heating operation are the same as before starting emergency operation.
• During the emergency operation, “
” lamp (yellow) ashes (0.5 second ON / 0.5 second OFF).
4.5.8.4 Operation with wired remote control
The indoor unit can also be operated with a wired remote control in addition of the installed receiver kit for wireless use.
Contact your dealer for more details.
Wired remote
control switch
(PC-ARF)
Wireless remote
control switch
(PC-LH3B)
To Next Page
Loading...
Need help?
General
