Hitachi PSC-A1T - Timer Setting Method

4 Individual remote controls
PC-LH3(A/B)
TCGB0106 rev.0 - 12/2014
181
4

Stop operation
Point the transmitter towards the receiver kit and press “RUN/STOP” switch again. The RUN indicator (red) of receiver is
turned OFF and the operation is stopped.
AUTO
The indications of setting temperature, fan speed and air ow angle are turned OFF.
4.4.4.5 Timer Setting Method

Function
This function is used to start or stop the unit operation at the setting time.
The timer setting is available for “ON TIME” and “OFF TIME”.
• ON TIME: The operation is started after the set time is passed.
• OFF TIME: The operation is stopped after the set time is passed.
Press “ON TIME” or “OFF TIME”. By repeatedly pressing “ON TIME” or “OFF TIME”, the indication of setting time is changed.
The setting time is available at half hour intervals up to 10 hours and at one hour interval up to 23 hours after 10 hours.
COOL
ON
TIMER
The setting time for “ON TIMER”
is set to 6 hours.
Flashing
Point the transmitter towards the receiver kit and press “SET” switch. The TIMER indicator (green) on receiver is turned
ON.
COOL
ON
TIMER
Stop ashing
Cancel setting
To cancel the timer setting, point the transmitter towards the receiver kit and press “CANCEL” switch. The TIMER indicator
(green) on receiver is turned OFF.
COOL