EasyManuals Logo

Hitachi PSC-A1T Technical Catalogue

Hitachi PSC-A1T
774 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #82 background imageLoading...
Page #82 background image
4.1.4 Operation
Before operation
CAUTION
Turn on the electrical power supply to the system approximately 12 hours before start-up after a long shutdown. Do not start the sys-
tem immediately after connecting the power supply, because the compressor may be damaged if it is not sufciently heated.
Make sure the outdoor unit is not covered with ice or snow. If it is, remove the ice or snow with warm water (no hotter than 50°C). If
the water temperature is over 50°C, the plastic parts may be damaged.
When the system is started after being out of use for more than 3 months, we recommend that the system is checked by the service
provider.
If the system is not going to be used for a long period of time, turn it off at the mains. Otherwise it will continue to consume electricity,
since the oil heater remains on even when the compressor is off.
4.1.4.1 Basic Operation
Operation start
Press “ ” (run/stop). The run indicator will be turned on and the
operation will be started.
A/C
MODE SPEED LOUV. TEMP
COOL
MED
Meeting Room
MODE ADJLOUV.
OK
Item selection
By pressing “
”or “ ”, the icon “ ” will move to the next item in
order of the indications “MODE”, “SPEED”, “LOUV.” and “TEMP”.
A/C
MODE SPEED LOUV. TEMP
COOL
MED
Meeting Room
MODE ADJLOUV.
OK
Change of settings
With the item (“MODE”, “SPEED”, “LOUV” or “TEMP”) selected,
press “
” or “ ”. The setting will be changed.
A/C
MODE SPEED LOUV. TEMP
HEAT
HIGH
SPEED ADJ
Meeting Room
OK
Operation stop
Press “
” (run/stop) again. The run indicator will be turned off and
the operation will be stopped.
NOTE
After the heating operation is stopped, the air ow operation may be acti-
vated for approximately 2 minutes.
A/C
MODE ADJTEMP
MODE SPEED TEMP
COOL
MED
Meeting Room
OK
Operation lock
This function is used to lock the setting from the remote control switch.
The following functions are applicable.
a. Operation Mode (MODE)
b. Temperature Setting (TEMP)
c. Fan Speed (SPEED)
d. Swing Louver Direction (LOUV)
4 Individual remote controls
PC-ARF
TCGB0106 rev.0 - 12/2014
66

Table of Contents

Other manuals for Hitachi PSC-A1T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hitachi PSC-A1T and is the answer not in the manual?

Hitachi PSC-A1T Specifications

General IconGeneral
BrandHitachi
ModelPSC-A1T
CategoryController
LanguageEnglish

Related product manuals