Hitachi PSC-A1T - Installation; Installation Site Selection; Components List

5.1.2 Installation
5.1.2.1 Installation site selection
Select a suitable place for handling and determine the installation place of the central station with the customer’s accept-
ance.
Do not install the central station at such places as:
- Where children can touch.
- Where the air from the air conditioner is directly discharged.
Before installing a controller, prepare the following items.
Parts Specication
Switch Box JIS Switch Box for 4 Switches (with cover) (JIS C8340)
Power Supply
Cable
Cable SPEC: 1.25 to 2mm
2
Recommended Cable: 600V CV, CCV, CEV
H-LINK Cable
(For Control)
Cable SPEC: 0.75 to 1.25mm
2
Recommended Cable: Twist Pair Cable with Shield,
Over 0.75mm
2
(Equivalent to KPEV-S)
* The recommended cables are the model name of Hitachi Cables, Ltd.
5.1.2.2 Components list
Unpack the unit and check that:
• The package contains all the components (see next table).
• All components are in perfect condition.
Otherwise, contact the manufacturer.
Name Quantity Comments
Central station
PSC-A64GT
1 For controlling system operation
M4x16L screws
4 For xing the central station
Touch pen
2
For activating/deactivating the touch op-
tions on the screen.
Touch pen holder
1
For holding the touch pen on the central
station
Installation and operation manual
1 Installation and operation unit instructions.
5 Centralised remote controls
PSC-A64GT
TCGB0106 rev.0 - 12/2014
220