4 Individual remote controls
PC-ART
TCGB0106 rev.0 - 12/2014
157
4
4.2.7.5 Remote control self-checking procedure
When to use the OK button:
1 When the remote control displays an operating fault.
2 For periodic maintenance checks.
Step
No.
Action required
1 Switch on the power source.
2
Press the following three buttons simultaneously.
(The buttons may be pressed when the system is running)
TEMP MODE
5
3
The LCD screen will change, as shown below.
No. LCD indication Indication period (seconds)
1
â
For 1 second
2
â
For 1 second
3
â
For 1 second
4
â
For 1 second
5
â
For 3 seconds
To delete EEPROM memory only, press the three following buttons simultaneously
during the LCD screen changes.
TEMP MODE
5
Go to 11
4 Once the LCD screen has changed, the RUN indicator will ash twice.
01
5
The LCD screen will change, as shown below.
Press all buttons (13), one at a time. Each time the button is pressed, the indication
number shown in part (A) of the following diagram will increase by one.
-
The check cannot proceed to the next step until all the buttons are pressed.
Part A
00
02
NOTE
The buttons may be pressed in any order.
If two or more switches are pressed at once, the action is not valid and is therefore not registered.
(continued on next page)
To Next Page
Loading...
Need help?
General
