Hitachi PSC-A1T - Operation; Test Run

6.1.5 Operation
6.1.5.1 Test run

Conguring the Hardware
After completing and checking the electrical installation, ensure that all the air conditioning units are running, and supply
power to CSNET WEB in order to congure the CSNET WEB interface
1 Connect the computer that will be used for conguration to CSNET WEB with a crossed Ethernet cable.
2 Insert the CD-ROM that is supplied with the CSNET WEB Packaged into the computer that is already connected. If the
Windows auto-start option is enabled, the installation programme will start automatically; if this option is not enabled,
execute the Autoinstall.exe application that is included in the CD-ROM.
3 The initial page for the installation will be displayed with the following options:
- CSNET WEB Congurator: open the CSNET WEB Congurator interface in order to congure and install your
installation.
- IP Change: Open the network settings of your system allowing change the IP of your computer.
- CSNET WEB Software: execute the CSNET WEB Software from the CD.
- Install CSNET WEB in PC: Install a copy of CSNET WEB in the local computer.
- CSNET WEB Manual: opens the technical catalogue of CSNET WEB.
- Upgrade CSNET WEB hardware: Upgrade the rmware of your CSNET WEB using our interface.
- Building Layout Software: Execute the Building Layout Editor in order to use this application to create a Building
Layout le.
6 Building air conditioning controls
CSNET WEB (PSC-A160WEB1)
TCGB0106 rev.0 - 12/2014
424424