4 Individual remote controls
PC-ARH
TCGB0106 rev.0 - 12/2014
162
3 Choose one of the following installation options for securing the remote control, depending on the installation re-
quirements:
- With remote control cable exposed.
- Using an electrical box.
- With a bedside table.
In cases where the remote control cable is exposed.
Secure the cable holder accessory to the wall using 2 M4 screws (ac-
cessories).
If using an electric control box.
There are different types of electrical boxes available on the market
that can be used for this installation, for example:
- Electrical box for one control unit (with or without cover.)
- Electrical box for 2 control units (with or without cover.)
- Other types of box
1 Pass the cable through the wall duct.
2 Pass the cable through the electrical box.
3 To secure the bracket to the box, make sure you leave the neces-
sary length of cable, taking into account the height of the terminals
A and B.
Screws M4 (eld supply)
Box
If using a bedside table
1 Cut a hole to leave the remote control exposed and prepare the bolts
(over 140 mm), as shown in the diagram.
NOTE
The bolts must be positioned in-line with the spacers (eld supply).
Bold
2 Fit the bolts into the xing bracket and secure the spacers with nuts.
- Bolt (eld supply).
- Nut (eld supply).
- Spacer (eld supply).
NOTE
Leave a distance of at least 30 mm between the spacer holes.
Bold(eld supply)
Spacer (eld supply)
Nut (eld supply)
or more
To Next Page
Loading...
Need help?
General
