4 Individual remote controls
PC-LH3(A/B)
TCGB0106 rev.0 - 12/2014
179
4
Air ow direction
Point the transmitter towards the receiver kit and press “LOUVER” switch to set the louver angle.
COOL
°C
Hi
The louver angle is set
to 1 step at “Hi” in the
cooling operation.
By pressing “LOUVER” switch, the louver angle will be changed as follows.
-
1
2
3
4
5
6
7
Step
LCD indication
COOL, DRY
HEAT, FAN
Auto-swing
Recommended
angle
Recommended
angle
Angle
range
Angle
range
: Auto swing operation will be started. At this time, the louver will swing repeatedly on LCD.
NOTE
• The louver angle is not displayed during the stoppage.
• The louver setting are only available from 1 step through 5 step and auto swing at the cooling and dry operation modes.
• The louver angle may be changed automatically during the heating operation. (Refer to the installation and operation manual of indoor
unit about detail.)
• The louver may NOT stop immediately right after the switch is pressed.
• The auto louver mechanism is not available for In-the-Ceiling type.
To Next Page
Loading...
Need help?
General
