4 Individual remote controls
Receiver kit for wireless remote control
TCGB0106 rev.0 - 12/2014
215
4
DIP switch for optional functions (DSW1)
Open the cover by removing the two screws in order to access the following functions.
PC-ALH3 PC-ALHP1
EMERGENCY
COOLHEAT
RUNFILTER DEFTIMER
PCB
123456
ON
Dip switch (DSW1)
(Factory-setting)
Rear side of receiver kit
Cover
Remove
the screw
Dip switch (DSW1)
(Factory-setting)
Rear side of receiver kit
Cover
PC-ALHZF
3412 56
ON
RUN
DEF
FILTER
TIMER
COOL
HEAT
EMERGENCY
PCB
Dip switch (DSW1)
(Factory-setting)
Cover
Outlet for
connecting cable
Case
Fixing braket
(1) Remove the xing bracket.
(2) Remove 2 xing screws to
open the case.
Operational function DIP switch adjustment Details
Secondary receiver adjustment.
1 2 3 4 5 6
Change the Main (OFF setting) / Sub (ON setting) remote
control switch used for two remote control system.
Identifying of indoor units
1 2 3 4 5 6
In case of ON setting, it performs as B mode (Identifying of
indoor unit) of wireless remote control switch.
Invalidity of Emergency Operation
1 2 3 4 5 6
The switches for emergency operation are invalid.
CAUTION
Pay attention to the following settings when the function for receiver kit is selected from the remote control switch or the centralized con-
troller.
• The cooling lower limit for setting temperature and the heating upper limit for setting temperature are not available. The setting is avail-
able beyond the upper and lower limit for setting temperature from the wireless remote control switch.
• The optional function setting “Fixing of Setting Temperature” is not available. When the operation mode is changed from the wireless
remote control switch, the indicated temperature on the remote control switch becomes set temperature.
To Next Page
Loading...
Need help?
General
