Hitachi PSC-A1T - Page 379


Restore settings
1 Select “Restore Settings” on the “Service Menu” screen.
NOTE
This function cannot be selected when remote control switch operation is prohibited, an external input contact is ON, or outdoor unit capac-
ity control is not cancelled. Cancel these parameters before performing “Restore settings”.
(1)
2 Tap “OK” at the conrmation screen.
NOTE
If “Cancel” is tapped, the screen returns to “Service Menu”.
3 A second conrmation screen is displayed. Tap “OK” here to restore the settings. The screen changes after several
seconds, and a check of the connections of the system starts.
NOTE
If “Cancel” is tapped, the screen returns to “Service Menu”.
(2)
(3)
Information
It is also possible to restore the settings when the “Start-up”
screen is being displayed.
1
Tap the “Restore” at the lower right corner of the “Start-
up” screen for more than 5 seconds.
* Restore settings is not displayed when remote control
switch operation is prohibited, an external input contact is
ON, or outdoor unit capacity control is not cancelled.
2
Connection check process starts after a few seconds.
3
When the process for connection check is nished, the
“Date and Time Settings” screen is displayed. (Refer to
Date and Time Settings)
Restore Settings
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
363
5