89
If no neighbor is specified, this command displays retransmission queue information for all neighbors.
Examples
# Display OSPF retransmission queue information.
<Sysname> display ospf retrans-queue
The Router's Neighbor is Router ID 2.2.2.2 Address 10.1.1.2
Interface 10.1.1.1 Area 0.0.0.0
Retransmit list:
Type LinkState ID AdvRouter Sequence Age
Router 2.2.2.2 2.2.2.2 80000004 1
Network 12.18.0.1 2.2.2.2 80000003 1
Sum-Net 12.18.1.0 2.2.2.2 80000002 2
Table 27 Command output
Field Descri
The Router's Neighbor is Router ID Neighbor router ID.
Address Neighbor interface IP address.
Interface Interface address of the router.
Area Area ID.
Retrans List Retransmission list.
Type LSA type.
LinkState ID Link state ID.
AdvRouter Advertising router.
Sequence LSA sequence number.
Age LSA age.
display ospf routing
Use display ospf routing to display OSPF routing information.
Syntax
display ospf [ process-id ] routing [ ip-address { mask | mask-length } ] [ interface interface-type
interface-number ] [ nexthop nexthop-address ] [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
process-id: Specifies an OSPF process by its ID in the range of 1 to 65535.
ip-address: Specifies a destination IP address.
To Next Page
Loading...
