HP 6125XLG - Lsp-Fragments-Extend

183
Views
IS-IS view
Predefined user roles
network-admin
Usage guidelines
This command enables sending logs about IS-IS neighbor state changes to the configuration terminal.
Examples
# Disable the logging of IS-IS neighbor state changes.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] undo log-peer-change
lsp-fragments-extend
Use lsp-fragments–extend to enable LSP fragment extension for a level.
Use undo lsp-fragments–extend to disable LSP fragment extension.
Syntax
lsp-fragments-extend [ level-1 | level-1-2 | level-2 ]
undo lsp-fragments-extend
Default
LSP fragment extension is disabled.
Views
IS-IS view
Predefined user roles
network-admin
Parameters
level-1: Applies the fragment extension to Level-1 LSPs.
level-1-2: Applies the fragment extension to both Level-1 and Level-2 LSPs.
level-2: Applies the fragment extension to Level-2 LSPs.
Usage guidelines
If no level is specified, the command enables LSP fragment extension for both Level-1 and Level-2.
Examples
# Enable LSP fragment extension for Level-2.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] lsp-fragments-extend level-2