281
Parameters
group-name: Specifies a peer group by its name, a case-sensitive string of 1 to 47 characters. The peer
group must have been created.
ip-address: Specifies a peer by its IP address. The peer must have been created.
ipv6-address: Specifies a peer by its IPv6 address. The peer must have been created.
hop-count: Specifies the maximum number of hop counts, in the range of 1 to 255. The default is 64.
Usage guidelines
EBGP peers must be directly connected. If not, use the peer ebgp-max-hop command to establish an
EBGP session over multiple hops between two peers. If direct EBGP peers use loopback interfaces to
establish a BGP session, you do not need to configure the peer ebgp-max-hop command.
Examples
# In BGP view, enable BGP to establish EBGP sessions to an indirectly-connected EBGP peer group test,
and specify the maximum hop count as 64 (default).
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test ebgp-max-hop
# In BGP-VPN instance view, enable BGP to establish EBGP sessions to an indirectly-connected EBGP
peer group test, and specify the maximum hop count as 64 (default).
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ip vpn-instance vpn1
[Sysname-bgp-vpn1] peer test ebgp-max-hop
peer enable
Use peer enable to enable BGP to exchange routing information for an address family with a peer or
peer group.
Use undo peer enable to disable BGP from exchanging routing information for an address family with a
peer or peer group.
Syntax
In BGP IPv4 unicast instance view/BGP-VPN IPv4 unicast instance view :
peer { group-name | ip-address } enable
undo peer { group-name | ip-address } enable
In BGP IPv6 unicast instance view:
peer { group-name | ipv6-address } enable
undo peer { group-name | ipv6-address } enable
In BGP-VPN IPv6 unicast instance view:
peer { group-name | ipv6-address } enable
undo peer { group-name | ipv6-address } enable
Default
BGP cannot exchange routing information with a peer or peer group.
To Next Page
Loading...
