HP 6125XLG - Ip Route-Static Default-Preference

29
Related commands
display ip routing-table protocol
ip route-static default-preference
Use ip route-static default-preference to configure a default preference for static routes.
Use undo ip route-static default-preference to restore the default.
Syntax
ip route-static default-preference default-preference-value
undo ip route-static default-preference
Default
The default preference of static routes is 60.
Views
System view
Predefined user roles
network-admin
Parameters
default-preference-value: Specifies a default preference for static routes, in the range of 1 to 255.
Usage guidelines
If no preference is specified for a static route, the default preference applies.
When the default preference is reconfigured, it applies to only newly added static routes.
Examples
# Set a default preference of 120 for static routes.
<Sysname> system-view
[Sysname] ip route-static default-preference 120
Related commands
display ip routing-table protocol