EasyManua.ls Logo

HP 6125XLG - Authentication-Mode

HP 6125XLG
466 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
62
mask-length: Specifies the mask length in the range of 0 to 32 bits.
cost cost: Specifies the cost of the summary route, in the range of 1 to 16777214. For Type-1 external
routes, the cost defaults to the largest cost among routes that are summarized. For Type-2 external routes,
the cost defaults to the largest cost among routes that are summarized plus 1.
not-advertise: Disables advertising the summary route. Without this keyword, the command advertises
the route.
tag tag: Specifies a tag for marking the summary route, in the range of 0 to 4294967295. The default is
1. The tag can be used by a routing policy to control summary route advertisement.
Usage guidelines
With the asbr-summary command configured, an ASBR summarizes redistributed routes that fall into the
specified address range into a single route and advertises the summary route in a Type-5 LSA to
neighbors. If the ASBR resides in an NSSA area, it advertises the summary route in a Type-7 LSA.
With the asbr-summary command configured, an NSSA ABR summarizes matching routes described by
Type-5 LSAs that are translated from Type-7 LSAs, and advertises the summary route to neighbors. This
command does not take effect on non NSSA ABRs.
To enable ASBR to advertise more-specific routes, issue the undo asbr-summary command.
Examples
# Summarize redistributed static routes into a single route, and specify a tag value of 2 and a cost of 100
for the summary route.
<Sysname> system-view
[Sysname] ip route-static 10.2.1.0 24 null 0
[Sysname] ip route-static 10.2.2.0 24 null 0
[Sysname] ospf 100
[Sysname-ospf-100] import-route static
[Sysname-ospf-100] asbr-summary 10.2.0.0 255.255.0.0 tag 2 cost 100
Related commands
display ospf asbr-summary
authentication-mode
Use authentication-mode to specify an authentication mode for the OSPF area.
Use undo authentication-mode to restore the default.
Syntax
authentication-mode { md5 | simple }
undo authentication-mode
Default
No authentication mode is configured for an area.
Views
OSPF area view
Predefined user roles
network-admin

Table of Contents

Other manuals for HP 6125XLG

Related product manuals