DR DR on the interface's network segment.
BDR BDR on the interface’s network segment.
MTU Interface MTU.
Options Options.
Dead timer due in 33 sec This dead timer will expire in 33 seconds.
Neighbor is up for 00:24:19 The neighbor has been up for 00:24:19.
Neighbor state change count Count of neighbor state changes.
Database Summary List Number of LSAs sent in DD packet.
Link State Request List Number of LSAs in the link state request list.
Link State Retransmission List Number of LSAs in the link state retransmission list.
# Display OSPFv3 neighbor statistics.
<Sysname> display ospfv3 peer statistics
OSPFv3 Process 1 with Router ID 1.1.1.1
-------------------------------------------------------------------------
Area ID Down Init 2-Way ExStart Exchange Loading Full Total
0.0.0.0 0 0 0 0 0 0 2 2
Total 0 0 0 0 0 0 2 2
Table 85 Command output
Field Description
Area ID Area ID.
Down
In this state, neighbor initial state, the router has not received any information from a
neighboring router for a period of time.
Init
In this state, the device received a Hello packet from the neighbor but the packet contains
no Router ID of the neighbor. Mutual communication is not setup.
2-Way
Mutual communication between the router and its neighbor is available. DR/BDR election
is finished under this state (or higher).
ExStart
In this state, the router decides on the initial DD sequence number and active/standby
relationship of the two parties.
Exchange In this state, the router exchanges DD packets with the neighbor.
Loading In this state, the router sends LSRs to request the neighbor for needed LSAs.
Full LSDB synchronization has been accomplished between neighbors.
Total Total number of neighbors under the same state.
display ospfv3 request-queue
Use display ospfv3 request-queue to display OSPFv3 request list information.
To Next Page
Loading...
