344
Parameters
process-id: Specifies a RIPng process by its ID in the range of 1 to 65535.
Examples
# Enable RIPng 100 on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng 100 enable
ripng metricin
Use ripng metricin to configure an interface to add a metric to inbound RIPng routes.
Use undo ripng metricin to restore the default.
Syntax
ripng metricin value
undo ripng metricin
Default
The additional metric of an inbound route is 0.
Views
Interface view
Predefined user roles
network-admin
Parameters
value: Add an additional metric to inbound routes, in the range of 0 to 16.
Examples
# Configure VLAN-interface 100 to add a metric of 12 to inbound RIPng routes.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng metricin 12
ripng metricout
Use ripng metricout to configure an interface to add a metric to outbound RIPng routes.
Use undo ripng metricout to restore the default.
Syntax
ripng metricout value
undo ripng metricout
Default
The additional metric of outbound routes is 1.
To Next Page
Loading...
