117
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf network-type nbma
Related commands
ospf dr-priority
ospf timer dead
Use ospf timer dead to set the neighbor dead interval.
Use undo ospf timer dead to restore the default.
Syntax
ospf timer dead seconds
undo ospf timer dead
Default
The dead interval is 40 seconds for broadcast and P2P interfaces. The dead interval is 120 seconds for
P2MP and NBMA interfaces.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the dead interval in the range of 1 to 2147483647 seconds.
Usage guidelines
If an interface receives no hello packet from a neighbor within the dead interval, the interface considers
the neighbor down. The dead interval on an interface is at least four times the hello interval. Routers
attached to the same segment must have the same dead interval.
Examples
# Configure the dead interval for VLAN-interface 10 as 60 seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf timer dead 60
Related commands
ospf timer hello
ospf timer hello
Use ospf timer hello to set the hello interval on an interface.
Use undo ospf timer hello to restore the default.
Syntax
ospf timer hello seconds
undo ospf timer hello
To Next Page
Loading...
