HP 6125XLG - Apply Origin; Apply Preference

422
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match as-path 1
[Sysname-route-policy-policy1-10] apply local-preference 130
apply origin
Use apply origin to set an ORIGIN attribute for BGP routes.
Use undo apply origin to restore the default.
Syntax
apply origin { egp as-number | igp | incomplete }
undo apply origin
Default
No ORIGIN attribute is set for BGP routes.
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
egp as-number: Sets the ORIGIN attribute to EGP. The as-number argument specifies an AS number in the
range 1 to 4294967295 for EGP routes.
igp: Sets the ORIGIN attribute to IGP.
incomplete: Sets the ORIGIN attribute to UNKNOWN.
Examples
# Configure node 10 in permit mode for routing policy policy1 to set the ORIGIN attribute for routes
matching AS path list 1 to IGP.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match as-path 1
[Sysname-route-policy-policy1-10] apply origin igp
apply preference
Use apply preference to set a preference for a routing protocol.
Use undo apply preference to restore the default.
Syntax
apply preference preference
undo apply preference
Default
No preference is set for a routing protocol.