HP 6125XLG - Default-Cost (Ospfv3 Area View); Default-Route-Advertise (Ospfv3 View)

351
• Configure a bandwidth reference value, and OSPFv3 computes the cost automatically based on the
bandwidth reference value: Interface OSPFv3 cost = Bandwidth reference value/Interface
bandwidth. If the calculated cost is greater than 65535, the value of 65535 is used.
If no cost value is configured for an interface, OSPFv3 computes the interface cost value automatically.
Examples
# Specify the reference bandwidth value as 1000 Mbps.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] bandwidth-reference 1000
default-cost (OSPFv3 area view)
Use default-cost to configure a cost for the default route advertised to the stub area.
Use undo default-cost to restore the default.
Syntax
default-cost cost
undo default-cost
Default
The cost is 1.
Views
OSPFv3 area view
Predefined user roles
network-admin
Parameters
value: Specifies a cost for the default route advertised to the stub area, in the range of 0 to 16777214.
Usage guidelines
This command takes effect only on the ABR of a stub area.
Examples
# Configure Area 1 as a stub area, and specify the cost of the default route advertised to the stub area
as 60.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] stub
[Sysname-ospfv3-1-area-0.0.0.1] default-cost 60
Related commands
stub (OSPFv3 area view)
default-route-advertise (OSPFv3 view)
Use default-route-advertise to redistribute a default route into the OSPFv3 routing domain.