HP 6125XLG - Display Ip Policy-Based-Route Setup

323
Table 70 Command output
Field Description
Policy based routing information for
interface Vlan-interface11(failed)
PBR configuration and statistics on VLAN-interface 11.
failed indicates that the policy (including all its nodes) failed to be
assigned to the driver.
For a global interface (with only a one-dimensional interface number, for
example, VLAN-interface 11), failed can be displayed only when you
specify the slot slot-number option for the command.
node 0 deny(not support)
node 2 permit(no resource)
Match mode of the node, permit or deny.
not support means the device does not support match criteria configured
on the node; no resource means the device has insufficient ACL
resources, and failed to assign ACL resources to the node.
For a global interface (with only a one-dimensional interface number, for
example, VLAN-interface 11), not support and no resource can be
displayed only when you specify the slot slot-number or chassis
chassis-number slot slot-number option for the command.
if-match acl Matches packets against the ACL.
apply next-hop Specify a next hop for permitted packets.
Matched: 0 (no statistics resource)
Number of successful matches on the node (no statistics resource
indicates insufficient statistics resources).
For a global interface (with only a one-dimensional interface number, for
example, VLAN-interface 11), no statistics resource can be displayed
only when you specify the slot slot-number or chassis chassis-number slot
slot-number option for the command.
Total matched Total number of successful matches on all nodes.
Related commands
reset ip policy-based-route statistics
display ip policy-based-route setup
Use display ip policy-based-route setup to display PBR configuration.
Syntax
display ip policy-based-route setup
Views
Any view
Predefined user roles
network-admin
network-operator
Examples
# Display PBR configuration.
<Sysname> display ip policy-based-route setup
Policy Name Interface Name