HP 6125XLG - Timer Lsp-Max-Age; Timer Lsp-Refresh

192
Usage guidelines
By adjusting the LSP generation interval, you can prevent bandwidth and router resources from being
over consumed due to frequent topology changes.
When network changes are not frequent, the minimum-interval is adopted. If network changes become
frequent, the LSP generation interval is incremented by the incremental-interval each time a generation
occurs until the maximum-interval is reached.
The minimum interval and the incremental interval cannot be greater than the maximum interval.
Examples
# Set the maximum interval, minimum interval, and incremental interval to 10 seconds, 100 milliseconds,
and 200 milliseconds.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1]timer lsp-generation 10 100 200
timer lsp-max-age
Use timer lsp-max-age to set the LSP maximum age in the LSDB.
Use undo timer lsp-max-age to restore the default.
Syntax
timer lsp-max-age seconds
undo timer lsp-max-age
Default
The LSP maximum age is 1200 seconds.
Views
IS-IS view
Predefined user roles
network-admin
Parameters
seconds: Specifies the LSP maximum aging time in the range of 1 to 65535 seconds.
Examples
# Set the maximum LSP age to 1500 seconds.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] timer lsp-max-age 1500
Related commands
timer lsp-refresh
timer lsp-refresh
Use timer lsp-refresh to configure the LSP refresh interval.
Use undo timer lsp-refresh to restore the default.